Autor: ~~ Guybrush Threpwood ~~ (guybrush_at_interia.pl)
Data: Sat 07 Oct 2000 - 21:07:24 MET DST
nie myslalem, ze to takie proste ;-)
jak za pare tygodni bede mial ME to bede probowal to powtorzyc.
----- Original Message -----
From: "Fusion" <7shadow_x7_at_pacbell.net>
Newsgroups: alt.comp.periphs.mainboard.abit
Sent: Saturday, October 07, 2000 12:12 PM
Subject: Success with KT7-RAID!!!
> After a long and exhausting week of trying to get the KT7-RAID stable I
> finally achieved success last night, and all I can say is WOW! What a
> difference. When this board is working correctly it screams. Here are
all
> the steps I took to get a stable system up and running. Some of this
> informations may not apply to your system, but all of this information and
> drivers can be found or referenced at http://go.to/kt7faq
>
> Start with a clean system. Remove all PCI cards leaving only the video
> card.
>
> 1. Flash BIOS with KTUL103.BIN beta version. BIOS settings will be reset
so
> you must re-configure settings. Do this at your own discression as it is
a
> beta.
>
> 2. Install windows with the SETUP /P I disables ACPI Support. Do custom
> installation, and make sure backup utility is not selected. I have a
> feeling ACPI is the cause of most problems with this board. It is a good
> concept in theory, but I do not believe the support for it has matured
> enough yet.
>
> 3. Install via 4in1a leaked drivers. Rename VIAMACH.CAT to VIAGART.CAT in
> C:\WINDOWS\INF\CATALOG directory before rebooting machine.
>
> 4. Install USBF108.EXE via usb filter drivers. Reboot Machine
>
> 5. Install 240075UP.EXE microsoft usb patch. Reboot Machine
>
> 6. Install latest DirectX. Reboot
>
> 7. Install latest video drivers. Shut Down
>
> 8. Place Sound Card in PCI slot 3 or 4. I used 3. Enable Legacy mode in
> BIOS for IRQ 5, DMA 1, and DMA 5. Install Sound Card drivers. Reboot.
>
> 9. Install 103 version of RAID drivers. BIOS revision on RAID controller
> should match driver revision. Reboot machine.
>
> 10. Add additional cards one at a time, and install the latest drivers for
> each device making sure to reboot after each install.
>
> 11. Install any additional software that you need.
>
> I would recomend using the following PCI configuration for systems using
an
> AGP video card.
>
> PCI 1 Dxr3 or other decoder card.
> PCI 2 Network Card
> PCI 3 Sound Card
> PCI 4 SCSI Card
> PCI 5 Try to avoid using this slot as it is shared with the RAID
controller.
> PCI 6 Any additional devices you may have.
>
> I hope this helps some of you out there experiencing the same problems
that
> so many people are having with this board.
>
> Any questions are welcome at 7shadow_x7_at_pacbell.net
> Remove both sevens to disable spam protection
>
> § Fusion §
To archiwum zostało wygenerowane przez hypermail 2.1.7 : Tue 18 May 2004 - 20:43:20 MET DST